HIGHWAY

What is Frost Action In Soils?

What is Frost Action In Soils?

 

When the ambient temperature falls below freezing for several days, it is quite likely that the water in soil pores will freeze. Since the volume of water increases by about 10 percent when it freezes, the first problem is the increase in volume of the soil.

The second problem is that the freezing can cause ice crystals and lenses that are several centimeters thick to form in the soil. These two problems can result in heaving of the subgrade (frost heave), which may result in significant structural damage to the pavement.


In addition, the ice lenses melt during the spring (spring thaw), resulting in a considerable increase in the water content of the soil. This increase in water significantly reduces the strength of the soil, causing structural damage of the highway pavement known as “spring break-up.”


In general, three conditions must exist for severe frost action to occur:
1. Ambient temperature must be lower than freezing for several days.
2. The shallow water table that provides capillary water to the frost line must be
available.
3. The soil must be susceptible to frost action.


The first condition is a natural phenomenon and cannot be controlled by humans. Frost action therefore will be more common in cold areas than in warm areas if all other conditions are the same.

The second condition requires that the groundwater table be within the height of the capillary rise, so that water will be continuously fed to the growing ice lenses.

The third condition requires that the soil material be of such quality that relatively high capillary pressures can be developed, but at the same time that the flow of water through its pores is restricted.


Granular soils are therefore not susceptible to frost action because they have a relatively high coefficient of permeability. Clay soils also are not highly susceptible to frost action because they have very low permeability, so not enough water can flow during a freezing period to allow the formulation of ice lenses.

Sandy or silty clays or cracked clay soils near the surface, however, may be susceptible to frost action. Silty soils are most susceptible to frost action. It has been determined that 0.02 mm is the critical grain size for frost susceptibility.

For example, gravels with 5 percent of 0.02 mm particles are in general susceptible to frost action, whereas well-graded soils with only 3 percent by weight of their material finer than 0.02 mm are susceptible, and fairly uniform soils must contain at least 10 percent of 0.02 mm particles to be frostsusceptible.

Soils with less than 1 percent of their material finer than the critical size are rarely affected by frost action.

Current measures taken to prevent frost action, include removing frost-susceptible soils to the depth of the frost line and replacing them with gravel material, lowering the water table by installing adequate drainage facilities, using impervious membranes or chemical additives, and restricting truck traffic on some roads during the spring thaw.

Tags: highwaySoil
The Engineering Community

Recent Posts

How Artificial intelligence (AI) can optimize bridges design?

How Artificial intelligence (AI) can optimize bridges design? Introduction:   Bridges are important pieces of infrastructure that connect communities and…

7 months ago

How AI can help in Highways and Railways design?

How AI can help in Highways and Railways design?   Introduction:   Artificial Intelligence (AI) has emerged as a transformative…

7 months ago

Enhancing Road Modeling Efficiency : Leveraging ChatGPT with Civil3D

Enhancing Road Modeling Efficiency : Leveraging ChatGPT with Civil3D Introduction: Road modeling is a critical component of civil engineering and…

11 months ago

What are Stirrups and Why we Use Them?

What are Stirrups and Why we Use Them?   Steel reinforcement is an essential component of reinforced concrete, providing tensile…

1 year ago

Why Are Spiral Curves Important? Benefits And Elements Of Spiral Curve

Why Are Spiral Curves Important? Benefits And Elements Of Spiral Curve   1. Introduction:   Spiral curves are an important…

1 year ago

The Main Types Of Tunnels

The Main Types Of Tunnels   Tunnels have been used for various purposes throughout history, from transportation and infrastructure to…

1 year ago

This website uses cookies.